Kenwood TH-D72A - Manual (Page 20)

11
[LIST] (5)
Press [LIST] to display the Station list.
Press [F], [LIST] to display the DX Cluster list .
[BCON] (6)
Press [BCON] to enter the Beacon Transmit mode (When TX Beacon method
is Manual) or turn the Beacon function ON or OFF (When TX Beacon method
is other than Manual) .
Press [F], [BCON] to enter the Quick Beacon mode .
[REV] (7)
Press [REV] to turn the Reverse function ON or OFF.
Press [REV] (1s) to turn the Automatic Simplex Checker ON.
Press [F], [REV] to enter the Voice Alert function setup mode .
[TONE] (8)
Press [TONE] to turn the Tone function ON.
• Each time you press [TONE], the function cycles through the following: Tone ON °
CTCSS ON ° DCS ON ° Cross Tone ON ° OFF.
• Additionally, when APRS is ON and Voice Alert is configured, Voice Alert ON is
added to the above cycle.
Press [F], [TONE] to enter the Tone frequency, CTCSS frequency, DCS code,
or Cross Tone setup mode.
Press [F], [TONE] (1s) to start the Tone frequency ID, CTCSS frequency ID,
or DCS code ID scan.
[PF] (9)
Press [PF] to activate its programmed function. The default function is
“Weather Channel” (TH-D72A)/ “Memory Name < > Frequency” (TH-D72E).
[MHz] ( )
Press [MHz] to enter the MHz mode.
Press [MHz] (1s) to start the MHz scan.
Press [F], [MHz] to enter Offset Direction setup mode.
• Each time you press [F], [MHz], the offset direction cycles through the following:
plus (+) direction
° minus (–) direction ° –7.6 MHz (TH-D72E only) ° OFF.
[DUAL] (0)
Press [DUAL] to switch the Single band mode and Dual band mode.
Press [F], [DUAL] to turn the Full duplex function ON or OFF.
[ENT] (#)
Press [ENT] to enter Frequency or Channel number entry mode.
Press [F], [ENT] to enter Frequency step setup mode.