Kenwood TH-D72A - Manual (Page 12)

3
• Be sure to match the battery polarities with those marked in the bottom of
the battery case.
3 Align the two tabs at the bottom of battery case, then close the cover until the
locking tabs on top click.
4 To install the battery case onto (or remove it from) the transceiver, follow steps
1 to 3 of “INSTALLING THE BATTERY PACK”.
• When using the BT-15, set the "Battery Type" to "Alkaline", in Menu No. 112 (page
24). If it is set to "Lithium", the battery capacity indicator (page 22) will not show the
correct initial value. When using the battery pack, return the setting to "Lithium".
Note:
X When carrying the battery case while using a battery pack, place the battery case in the BT-15
carrying pouch.
X Do not use Manganese batteries or Rechargeable batteries in place of Alkaline batteries.
X Remove all batteries from the case when it is not expected to be in use for several months.
X To lift the battery pack safety catch, use a piece of hardened plastic or metal, such as a
screwdriver, that is no more than 6 mm wide and 1 mm thick. It is imperative that you place the
implement under only the lip of the safety catch so that you do not damage the release latch.
,167$//,1*7+(%(/7&/,3
If desired, you can install the supplied belt clip to the transceiver.
1 Loosely insert the two supplied screws into the holes on the back panel of the
transceiver.
2 Slide the belt hook into position, under the screws.
3 Tighten the screws until secure.
Note: When the belt hook is not attached to the transceiver, remove the screws from the
transceiver to avoid scratching other materials.