Kestrel 4500NV Applied Ballistics Meter - Manual (Page 25)

25
Measurement screens
• Press or to scroll through the Measurement
screens.
Measurement Modes
• From your chosen Measurement screen, use or to
scroll through the Mode options:
Current: Displays instantaneous reading.
Min/Max/Avg: Displays the Minimum, Maximum, and
Average readings from stored data (Displays --.- if no data
has been stored).
Chart: Displays graph of stored data points for each
measurement.
Current Min/Max/Avg Chart
TEMP F
76.4
TEMP F
Min 32.4
Avg 67.9
Max 84.0 TEMP F
— for data
To View Chart Data:
• Press while viewing a chart. A cursor will appear on
the most recent data point.
• Press or to scroll through saved data:
56.0 F
Feb 27 16:58:14
The data value will be displayed at the top of the screen.
The date and time when each data point was stored will be
displayed at the bottom of the screen.
• Press
or to review the chart data for other
measurements.
MAX/AVG FunCTIOns - Wind speed & Wind Chill
These values are measured independently from stored
and charted data to allow the user to start and stop the
averaging period in the manner most appropriate for
their application. Averaging on all wind-related values
will be started and stopped together.
To measure these values:
• Press or to scroll to a wind measurement
screen, then use or to select Min/Max/Avg screen.
• Press to begin collecting data.
• Press again to stop data collection and display the
Maximum and Average values.
This routine will work simultaneously for both
measurements, regardless of which one is displayed when
run. No other Min/Max/Avg or stored data will be affected.
• To clear data, press when the screen says “— clear”.
Other measurements will display min / max / avg data
based on the data stored in the log (using either auto-
stored or manually captured data). This data can be
cleared by using “Reset MMA” under memory options.
Backlight
• Press to activate backlight for one minute.
• Press again to deactivate the light manually.
sCREEn nAVIGATIOn