Kestrel 4500NV Applied Ballistics Meter - Manual (Page 24)

24
• Use or to scroll to the desired Measurement
screen.
• Press or to turn screen “On” and “Off”.
The Kestrel Meter will continue to log data for hidden
measurements. To view logged data of the hidden
measurement, go to Measurement setup, select the
Measurement screen you want to view, and turn it back
“On.”
When the Kestrel is in Chart mode, the upper and lower
limits of the graph scale may need to be adjusted to fully
view all data points. You can customize these value limits
using the Graph Scale setup.
• Press
or to scroll to the Measurement you want
to adjust, then press .
• In the new screen, use or to highlight “Set High”
or “Set Low”.
• Press or to adjust the value limit of your
chosen option.
units
This setup option lets you select units of measure to best
suit your application.
• Use
or to scroll to each measurement.
• Press or to change the unit of measurement.
user screens
The Kestrel allows you to set up to 3 customized User
Screens that will display 3 current Measurement values
on the same screen. These screens are helpful for quick
reference if you need to monitor multiple measurements
at once. The User Screen option allows you to customize
your user screens.
• Press or to highlight .
User Screen 1, 2 or 3, then press .
• Use or to set your preferred measurement option.
• Press or to highlight
the remaining lines, and use or to set those
Measurement options.
Repeat these steps to set up the other User Screens.
When accessed through the Measurement navigation,
each User Screen will display current data for the chosen
measurements as programmed.
Sample User Screen
User Screen 2
22.5 °F
48.6 %
1014.6 inHg
sETup & OpTIOns (COnT.)