Dake Utility - Bench - Manual (Page 6)

5
4. ASSEMBLY INSTRUCTIONS :
FOR DAKE MODEL UTILITY 10 TON BENCH AND FLOOR MODEL PRESSES.
Your new Dake Press has been packaged in a manner to prevent damage to any critical
components, some assembly will be required. All parts in the accessory box are critical to
the function of your press. Please review the list of materials to insure you have all
components required. Please refer to the parts list and exploded diagrams on pages 10-13
of this owners manual.
Your press head frame, uprights and head traverse ram plate has been pre-assembled at
the factory. You will be required to install the worktable, ram, pumping unit and base angles.
Follow the simple instructions below for quick assembly. Assembly may be made easier if
the frame is laid down flat with the front facing upward.
STEP 1: Bench model:
Using (2) M8 x 20mm bolts, nuts and washers install the union support to the bottom from of
the upright channels. (Pump hanger bracket on the right hand side of the upright.) Angle is
to face outward see drawing below on right.
Hand tighten.
Pump hanger bracket
Union support
STEP 1 . Floor model:
Install the union support to the inside of the upright channels and base angles, using the 4 of
the M8 x 25mm bolts, nuts and washers provided. Place union support in-between the
channels, and install the 2 base angles to the frame through the union support and install
nuts. Base angles face outward (See drawing below) Hand tighten.
Base angle
Union support
Union support
Base angle