Summers 50' Superroller - Manual (Page 20)

SECTION 2 - ASSEMBLY
ROLLER_INSTALL 12/11/2013 9LR4542.iam/
8R8010
8X0111A
3/4" X 2-3/4"
8P5080
8X0306
3/4" LW
8X0265
3/4" LN
8R8005
SNAP RING
8P4213 - 41' MACHINE WIDTH
8P4215 - 45' MACHINE WIDTH
8P4205 - 50' MACHINE WIDTH
STAMPED H LOCATION.
POSITION TOWARDS MACHINE
CENTER, NEXT TO HINGE.
8P3010
PLUG 2-1/2" NPT
8X0364
2-1/2" FW
(AS REQUIRED ON
OUTSIDE WING SO
WING ROLLER AND
WING STOP
CONTACT CENTER
IN TRANSPORT)
WING ROLLER INSTALLATION
2-10
WR1. Clean Roller pivot shafts.
WR2. Position Rollers below Wings. CAUTION: Each Roller weighs up to 4285#, block to prevent
unexpected movement. Be careful when moving them. Use extreme caution when centering
on frame.
WR3. NOTE: An H has been stamped onto one end of each roller, position this H next to the Wing
Hinge.
WR4. Install Bearings with grease zerk towards rear of machine. Apply anti-seize to shaft. Secure
to bolt plates with 3/4” x 2-3/4” bolts, lock washers and locknuts. Install Reinforcement Angles
between bottom attachment holes on inside of the bolt plate.
WR5. On the outside bearings only, install 2-1/2” ID flat washers before installing snap ring. Install
Snap Rings (8R8005). Adjust quantity of 2-1/2” ID flat washers so Wing Stop and Roller con-
tact Center at same time. See page 3-7.