Center roller installation, Set-up of frame -3 – 2-9 – Summers 50' Superroller User Manual
Page 13
SECTION 2 - ASSEMBLY
CENTER_ROLLER
1/14/2014
9LR4542.iam/
8R8005
SNAP RING
8P5080
8R8010
8X0306
3/4" LW
8X0265
3/4" LN
8P4020 (36")
8P4040 (42")
8P4203 (36")
8P4215 (42")
8X0111A
3/4" X 2-3/4"
2-3
CENTER ROLLER INSTALLATION
CR1. Position Center Roller on a firm, level surface. CAUTION: Each Roller weighs up to 4285#,
block to prevent unexpected movement.
CR2. Clean Roller pivot shafts.
CR3. Lower Center Frame over Roller. The Center weighs 2424#, use extreme caution when po-
sitioning over Roller.
CR4. Install bearings with grease zerks toward rear of machine. Apply anti-seize to shaft. Secure
to bolt plates with 3/4” x 2-3/4” bolts, lockwashers and locknuts. Install Reinforcement Angles
(8P5080) between bottom attach holes on inside of bolt plates.
CR5. Install Snap Rings.