Summers 50' Superroller - Manual (Page 18)

SECTION 2 - ASSEMBLY
WING 12/31/2009 9LR4542.iam/
8P3910
8X0253
NY-LOCK 5/8"-11NC
8X0304
5/8" LW
8X0323
5/8" FW
8X0095
5/8" X 5"
8D9108
1/4 X 2" RP
8K9106
8C0532
8S3059
2.067" CAPLUG
8X0281
NY-LOCK 1"
8P5070
8D0340
3/4 X 4 X 7-3/4" 8X0143
1X5"
8X0260
3/4" N
8X0306
3/4" LW
8X0282
8X0316
1" FW
8P3500
8L0252
8T3300
8P3500
41' 45' 50'
8P4067 - LEFT 8P4070 - LEFT (SHOWN) 8P4075 - LEFT
8P4077 - RIGHT 8P4080 - RIGHT 8P4085 - RIGHT
WING INSTALLATION
2-8
W1. Connect Left and Right Wings with 2” x 13-1/2” Pins. Position retaining holes in the inside
of pivots. Retain pins with 5/8” x 5” bolts, washers and nuts.
W2. Connect rod end of wing lift cylinders as shown. Do Not Overtighten Pivot Bolt (8T3300).
Pivot Bolt must be free to rotate (see photo P-W1).
W3. Steps to adjust Cylinder Attach Eye Bolts:
a. Grease Zerks on Wing and Center pivots.
b. Raise Wings by retracting Wing Lift Cylinders.
c. Adjust Wing Lift Cylinder Eye Bolts so wing stop rests on center section when cylin-
ders are fully retracted (see photo P-W3).
d. With Wings folded up tilt machine forward by retracting Center Tilt Cylinder.
e. Adjust Center Tilt Cylinder Eye Bolt so wings rest on Transport Rest when cylinder is
fully retracted (see lower photo page 2-14).
f. Lower machine to Field Position.
W4. Install Wing Locks at location shown. Tighten 1” Lock Nut until one thread is past nylon
lock. Distance between 8P5070 is required for Safety Chain to pass through.
W5. Install 8S3059 Plugs behind rear pivot pins (see photo P-W2).