Hawkeye Float User Manual

Page 2

Hawkeye Industries Inc.

Remove the housing cap from the float guide

assembly and pull out the cable clamp and ex-

cess cable.

Turn the thumb screw counter clockwise to

loosen cable. Pull the cable and cable clamp

upwards until taut.

Turn thumb screw clockwise to secure cable.

Use the 9/16 wrench to tighten the sealing nut.

Loosen the cable clamp using the 5/16 wrench,

and reposition as near to the cable lock pocket

as possible.

Cut off the excess cable, leaving enough to

grab onto if future adjustement is required.

Position the remaining cable and cable clamp

into the pocket and replace the housing cap

with the pipe wrench. Repeat 5-9 with second

float gude cable lock assmbly.

MOVE
DOWNWARDS

LOOSEN

TIGHTEN

5.)

6.)

7.)

10.)

9.)

8.)

►

Float Guide Kit Installaton Complete

B.) Installing Float Guide Kit on an In-Service Tank

If the tank is in service and/or internal access is impossible, the float guide kit may still be installed with the aid of a hook long enough to

reach from the thief hatch to the float guide couplings and a Hawkeye float cable guide anchor plate.

Label the free end of the guide cable to identify which cable lock it is con-

nected to. Insert the end of the cable with the strap fork from the float

guide cable lock assembly into the 1-1/4 NPT couplings and feed down

into the tank.

Apply thread sealant on the bottom threads of the float guide cable lock

assembly housing and install into the 1-1/4 NPT coupling with the pipe

wrench. Repeat with the second float guide cable lock assembly.

1.)

2.)

►