beautypg.com

Enable/disable outputs – AMETEK 1995L Micro-Set PLS User Manual

Page 17

background image

13

Installation and Maintenance Manual

Chapter 3: Programming

The enable/disable feature is programmed as follows:

A)

Unit must be in the “Program” mode.

B)

Depress

CIR# 380 Enables the Outputs.

CIR# 381 Disables the Outputs.

CIR# (380 or 381)

-

ENT

-

.

NOTE: If you try to disable the outputs in the Run mode, the unit will display “EEE”.

3.18: Enable/Disable Outputs

During setup, the outputs may be enabled or disabled. When outputs are selected to be disabled, the

status LEDs and the relays will be OFF. The unit must be in the Program mode to disable the outputs;

as soon as the unit is switched to the Run mode, the outputs will be enabled.

See also other documents in the category AMETEK Sensors: