ARI Armaturen BR015-ZIVA-G EN - Manual (Page 8)

Page 8 Rev. 0040201000 0511
Operating and installation instructions
ZESA
®
/ GESA
®
/ ZIVA
®
-Z / ZIVA
®
-G
5.3 Conversion from notch lever to lock lever
fig. 7
The notch lever cap (pos. 7) can be used for the conversion.
- Set notch lever (pos. 50) to notch position 4.
- Slacken socket screw (pos. 50.2 / SW 5 of 6 mm AF).
- Remove notch lever (pos. 50).
- Dismantle notch lever cap (pos. 7) and use a screwdriver to break out the window.
- Put the cap, with the
nut (pos. 19) in it, in place and tighten it.
- Set the lock lever (pos. 50.1) in position as shown in the diagram.
- Tighten the socket screw (pos. 50.2).
- Insert star knob screw (pos. 60) through the hole at the end of the lock lever (pos. 50.1)
and screw into the hex. nut (pos. 19).
If the lock lever must be on the same side as the original notch lever, the notch lever cap
must be turned through 180
°.
For the angle limit stop, an additional nut can be placed in the cap for a locking screw.
ATTENTION !
The position of the valve disc is not positively located!
window