Red Lion PMKCC - Manual

1
PMKCC1 & PMKCC2
These panel mount kits adapt 1/16 DIN meters to either a 50 mm x 50 mm or
a 68 mm x 68 mm panel cut-out. The kit consists of two metal panel adaptors,
one neoprene gasket and 2 3-48 x 1/2" screws. The adapter plates and gasket are
pinched between the front bezel of the meter and the mounting clip. The 1/2"
long screws may be necessary for thicker panel installations.
Note: If room permits, make the wiring connections after the unit is mounted. If
there is not enough room, pull the wires through before installing as
described below:
1. Pull the wires through the following items in order:
a) One panel adapter plate.
b) Through existing panel opening.
2. Slide the following items onto the counter.
a) Panel gasket
b) Adapter plate
c) Adapter gasket
3. Slide meter through panel cut-out from the front, and center in the panel
opening.
5. Install the mounting clip. Tighten the screws moderately to “pinch” the
gaskets and panels between the front bezel and the mounting clips.
INSTALLATION FOR 1/16 DIN PANEL MOUNT KITS
PMKCC1 PMKCC2 PMKCC3
Three panel mount kits for 1/16 DIN meters are available to replace many existing meters on the
market today. Kits come complete with adapter plates coated with a durable flat black polyurethane
finish, mounting hardware, and gaskets.
DIMENSIONS In inches (mm)
PMKCC1 PMKCC2 PMKCC3
Bulletin No. PMKCC-B
Drawing No. LP0090
Released 02/09
Tel +1 (717) 767-6511
Fax +1 (717) 764-0839
www.redlion.net