Red Lion PMKG1 - Manual

1
The Gemini Series panel adapter kit permits the mounting of the Gemini unit
to an existing 68 mm x 138 mm DIN standard panel cut-out. The kit consists of
two metal adapter plates coated with a durable flat black polyurethane finish,
and a neoprene gasket, which provides a sealed front panel that meets NEMA
4/IP65 specifications when properly installed.
DIMENSIONS “In inches (mm)”
Note:
An overall panel area
of 3” x 6” is required
for proper mounting.
INSTALLATION
1. Remove the backing from the adhesive side of the adapter gasket (included
with adapter kit) and carfully stick the gasket to the front of the existing
panel cut-out.
2. Apply the standard panel mount gasket (provided with the Gemini unit) to
one of the adapter plates and slide the plate over the Gemini unit. (Gasket
side must be facing the bezel.)
3. Insert the Gemini unit into the panel cut-out from the front and slide the
remaining adapter plate over the Gemini unit from the rear.
4. Install the two mounting clips (provided with the Gemini unit) as per the
instructions in the Gemini manual. Install the screws into the mounting
clips and tighten them evenly to apply uniform compression and to provide
a water-tight seal.
CAUTION: Only minimum pressure is required to seal the panel. Do NOT
overtighten the mounting screws.
GEMINI SERIES PANEL ADAPTER KIT FOR DIN PANEL CUT-OUTS
MODEL NO. DESCRIPTION PART NUMBER
3-PIECE KIT permits mounting to existing
PMKG1 2.67” x 5.43” (68 mm x 138 mm) Panel cut-out, PMKG1000
O.A. DIM. 3” x 6” (76.2 mm x 152.4 mm)
ORDERING INFORMATION
INTERNATIONAL HEADQUARTERS EUROPEAN HEADQUARTERS
20 Willow Springs Circle, York, Pa. 17402, (717) 767-6511 FAX: (717) 764-0839 892 Plymouth Road, Slough, Berkshire SL1 4LP
Web site- http://www.redlion-controls.com E-mail- [email protected] ENGLAND +44 1753 696888 FAX: +44 1753 696339
RED LION CONTROLS
BULLETIN NO. PMKG1-B
DRAWING NO. LP0094
REVISED 4/96