HighPoint RocketRAID 2322 User Manual
Page 61
Linux Driver Support
Step 4 Configure System to Automatically Load the Driver
To avoid typing in “insmod rr232x.o” each time the operating system is booted, the
system must be instructed to automatically load the module during bootup. To install
the module, type in the following commands (first change to the directory where the
proper rr232x.ko file is located):
1.
Edit the file “/etc/sysconfig/kernel”, and add the rr232x module to the line
“INITRD_MODULES=…”
Example:
INITRD_MODULES=”reiserfs rr232x”
2.
Run the “depmod” command to update the module configuration:
# depmod
3.
Next, run the “mkinitrd” command to update the initrd file:
# mkinitrd
4.
If you are using the lilo boot loader, run lilo again:
# lilo
Step 5 Configure System to Mount Volumes during Startup
The system can be instructed to automatically mount the array(s) during startup by
modifying the file”/etc/fstab”.
For example, add the following line to tell the system to mount /dev/sda1 to location /
mnt/raid after startup:
/dev/sda1 /mnt/raid ext2 defaults 0 0
5-13