HighPoint RocketRAID 2322 - Manual (Page 52)

Linux Driver Support
Step 4 Configure System to Mount Volumes during Startup
The system can be instructed to automatically mount the array(s) during startup by
modifying the file”/etc/fstab”.
For example, add the following line to tell the system to mount /dev/sda1 to location /
mnt/raid after startup:
/dev/sda1 /mnt/raid ext3 defaults 0 0
3 - Updating the Driver
1. If the original driver is installed in the system’s initrd (Initial RAM Disk) file
(when using a system installed to RR2322 controller, for example), the driver
module in the initrd file should be updated using the mkinitrd command (or
extract the initrd file and replace the driver module manually).
2. If the original driver is installed in the /lib/modules/‘uname –r‘/kernel/drivers/
scsi/ directory, and loaded by the script file (Example /etc/init.d/hptdriver) during
the init process, or the configure file (Example /etc/modules.conf), please replace
it with the new driver (rr232x.ko).
4 - Uninstalling the Driver
To uninstall the RocketRAID 2322 driver
Note: The driver cannot be uninstalled while the system is booted from a disk or array
attached to the RocketRAID 2322.
To uninstall the driver, remove the lines added to /etc/fstab, and remove the files
created in the /etc/init.d directory.
5-4