Audiovox P-48 - Manual (Page 9)

-7-
DETACHING THE FRONT PANEL
ATTACHING THE FRONT PANEL
1. Make sure the front panel is right-side-up when attaching it to
the chassis as it cannot be attached when up-side down.
2. Do not press very hard on the front panel when attaching it
to the chassis. No more than light to moderate pressure
should be needed.
3. When attaching the front panel, make sure the right side is
correctly engaged before pressing the left side to lock it into
position.
4. When taking the front panel with you, please use the supplied
carrying case to protect the panel from dirt and damage.
Make sure there is no dust or dirt on the electrical terminals
on the back of the panel as this could cause intermittent
operation or other malfunctions.
NOTES ON USE OF FRONT PANEL
1. Switch the vehicle ignition and radio “on”.
2. If necessary, momentarily press the Time/Frequency Selector button
cp
so that the time is shown on the display panel.
3. Press and hold the Time/Frequency Selector until the time display begins flashing. While the display is still flashing, press the Down
Tuning ( ) button to adjust the hours and then the Up Tuning ( ) button to adjust the minutes to the correct time.
4. Five seconds after the last hour or minute adjustment is made, the time will be set in the unit and the display will return to the normal
indication.
Release Button
Engage right
side first
SETTING THE CLOCK