Audiovox CE148 - Manual

IMPORTANT SAFETY INSTRUCTIONS
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT
EXPOSE THE UNIT TO RAIN OR MOISTURE.
TO AVOID ELECTRICAL SHOCK, DO NOT OPEN THE
CABINET.
REFER SERVICING TO QUALIFIED PERSONNEL ONLY.
INFORMATION (For the Customers in U.S.A)
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet that is on a circuit different
from the one the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
You are cautioned that any changes or modifications not expressly
approved in this manual could void your authority to operate this
equipment.
For the Customers in the United Kingdom and/European
Countries
This Compact Disc player is
classified as a CLASS 1 LASER
product.
The CLASS LASER PRODUCT label
is located on the bottom exterior.
For the Customers in Canada
This apparatus complies with the Class B limits for radio noise emissions
set out in radio interference regulations.
CAUTION
The use of optical instruments with this product will increase eye hazard.
On safety
As the laser beam used in this compact disc player is harmful to
the eyes, do not attempt to disassemble the casing. Refer servicing to
qualified personnel only.
Do not put any foreign objects in the safety slot inside the disc
compartment. If you do so, the laser beam may come out when the lid is
opened.
Do not put any foreign objects in the DC IN 6V (external power input) jack.
Should any solid objects or liquid fall into the unit, disconnect the power
supply and have the unit checked by qualified personnel before operat-
ing it any further.
On operation
Since the CD system offers a wide dynamic range, the peaks of the high
level inputs are recorded with high fidelity, and the noise level is very
low. Do not turn up the volume while listening to a part of the disc with
no audio signals or very low level inputs. If you do, the speakers may be
damaged when the peak level of the sound is played. The lens on the
disc table should be kept clean. Do not touch the lens or poke at it. If you
do, the lens may be damaged and the unit will not operate properly.
On installation
Never install the unit where it would be subjected to:
- heat sources such as radiators or airducts
- direct sunlight
- excessive dust
- moisture or rain
- mechanical vibration or shock
- unleveled surface
• Do not place any heavy object on top of the unit.
• When the unit is used with an AC power adaptor, do not wrap the unit
in a cloth, blanket, etc. If you do, the temperature inside and outside
the unit may rise considerably, resulting in malfunctioning of the unit
or serious accidents.
• If the unit is brought directly from a cold to a warm location, or is
placed in a very damp room, moisture may condense on the lens
inside the unit. Should this occur, the unit will not operate. In this case,
remove the disc and leave the unit in a warm place for several hours
until the moisture evaporates.
• For the unit to operate at its best, it should not be subjected to
temperatures below 5°C (41°F) or above 35°C (95°F).
Notes on headphones/earphone
Do not use headphones/earphone while driving, cycling, or operating
any motorized vehicle, it may create a traffic hazard and is illegal in
some areas. It can also be potentially dangerous to play your headsets
PRECAUTIONS
1. Read Instructions - All the safety and operating instructions should
be read before the appliance is operated.
2. Retain Instructions - The safety and operating instructions should
be retained for future reference.
3. Heed Warnings - All warnings on the appliance and in the operating
instructions should be adhered to.
4. Follow Instructions - All operating and use instructions should be
followed.
5. Water and Moisture - The appliance should not be used near water
- for example, near a bathtub, washbowl, kitchen sink, laundry tub,
in a wet basement, or near a swimming pool, and the like.
6. Ventilation - The appliance should be situated so that its location or
position does not interfere with its proper ventilation. For example,
the appliance should not be situated on a bed, sofa, rug, or similar
surface that may block the ventilation openings; or, placed in a
built-in installation, such as a book case or cabinet, that may impede
the flow of air through the ventilation openings.
7. Heat - The appliance should be situated away from heat sources
such as radiators, heat registers, stoves, or other appliances
(including amplifiers) that produce heat.
8. Power Sources - The appliance should be connected to a power
supply only of the type described in the operating instructions or as
marked on the appliance.
9. Grounding or Polarization - Precautions should be taken so that
the grounding or polarization means of an appliance are not
defeated.
10. Power-Cord Protection - Power-supply cords should be routed so
that they are not likely to be walked on or pinched by items placed
upon or against them, paying particular attention to cords at
plugs, convenience receptacles, and the point where they exit from
the appliance.
11. Cleaning - The appliance should be cleaned only as recommended
by the manufacturer.
12. Nonuse Periods - The power cord of the appliance should be
unplugged from the outlet when left unused for a long period of
time.
13. Object and Liquid Entry - Care should be taken so that objects do
not fall, and liquids are not spilled, into the enclosure through
openings.
14. Damage Requiring Service - The appliance should be serviced by
qualified service personnel when:
A. The power-supply cord or the plug has been damaged; or
B. Objects have fallen, or liquid has been spilled into the
appliance; or
C. The appliance has been exposed to rain; or
D. The appliance does not appear to operate normally or exhibits a
marked change in performance; or
E. The appliance has been dropped, or the enclosure damaged.
15. Servicing - The user should not attempt to service the appliance
beyond that described in the operating instructions. All other servicing
should be referred to qualified service personnel.
CAUTION
INVISIBLE LASER RADIATION
WHEN OPEN AND INTER-
LOCKS DEFEATED.
AVOID EXPOSURE TO BEAM
This product contains
a low power laser
device.
CLASS 1 LASER PRODUCT
APPAREIL À LASER DE CLASSE 1
PRODUCTO LASER DE CLASE 1
PRODUTO LASER CLASSE 1
Opening the CD Door
to insert or remove a CD
Play/Pause
Press to begin play.
Press during play to pause.
To release pause, press pause.
(stop) /OFF (power off)
Disc playing stops, press again the unit will be
off.
Track search and fast forward/fast reverse
Press
lightly/repeatedly:
To locate the beginning of the current selection or
previous selections.
Keep depressed:
To go back at high speed (search)
Press lightly/repeatedly:
To locate the beginning of next selection/
selections.
Keep depressed:
To go ahead at high speed (search)
PRESET/PLAY MODE
Press the PRESET button in RADIO, after the
preset number appear, turn in a station using
preset.
P.MODE button for selecting the various play
mode.
MEMORY/REPEAT/ENTER
Press the MEM(MEMORY) button to storing
stations.
Enter button/Repeat button.
FUNCTION (CD/RADIO)
Set to CD or RADIO function.
BAND
Press the BAND button repeatedly to select
AM(MW) or FM to turn on radio.
OFF
Power off
TUNING (DOWN/UP)
Press the TUNING buttons turn into a station.
PHONES jack
For connecting the headphones/earphone.
X-BASS
OFF: normal sound
ON: bass sounds are amplified
Mains socket (DC IN 6V)
Volume
Adjust the VOLUME.
ANTI-SHOCK
Press ANTI-SHOCK button to prevent sound
skipping.
M1, M2, M3, M4, M5, M5+
Preset number station buttons
FUNCTION OF CONTROLS
TUNING
BAND
OFF
PRESET/P. MODE
MEM/REPEAT/ENTER
Using with batteries
Insert two size AA batteries (LR6 or UM-3 alkaline) according to the
" " and " " indications in the battery compartment.
Inserting batteries
Detach the battery cover on the
middle cabinet and insert two
size AA batteries (LR6 or UM-3
alkaline)
Notes on batteries
• Insert batteries with correct polarity.
• Do not use old batteries together with new ones or different types of
batteries together.
• If the electrolyte inside the battery should leak, wipe the contaminated
parts in the battery compartment with a cloth and replace the old
batteries with new ones.
• When the unit is not to be used for a long period of time, remove the
batteries.
• Do not mix old and new batteries.
Do not mix ALKALINE, standard (CARBON-ZINC) or rechargeable
(NICKEL-CADMIUM) batteries.
POWER SOURCES
M1~M5 +
Portable Radio/CD Player
Operating Instruction
Before operating the unit, please read this manual thoroughly and
retain it for future reference.
at high volume while walking, especially at pedestrian crossings. You
should exercise extreme caution or discontinue use in potentially
hazardous situations.
Avoid using headphones/earphone at high volume. Hearing experts
advise against continuous, loud and extended play. If you experience a
ringing in your ears, reduce volume or discontinue use.
Keep the volume at a moderate level. This will allow you to hear outside
sounds and to be considerate to the people around you.
If you have any questions or problems concerning your unit, please
consult your nearest dealer.
ANTI-S HOCK
ON/OFF