Haws 2500.CT - Manual (Page 7)

6/13 Model 2500.CT Page 7 of 12
Operation
Dispensing Cold Water
To dispense cold water, press and
hold the “Cold” button until the unit
beeps and ring around the “Water”
button turns blue (about 1 second).
Press and hold the “Water” button to
dispense; release the button to stop
dispensing.
Dispensing Hot Water
To dispense hot water, press and hold the “Hot” button until the unit beeps and ring around
the “Water” button turns red (about 3 seconds). Press and hold the “Water” button to
dispense; release the button to stop dispensing.
CAUTION: Water dispensing from the hot tank is sufficiently hot to cause injury. Take care
when dispensing hot water.
Maintenance
Filter Changes
NOTE: Filter life is 1500
gallons or 12 months,
whichever comes first. With
higher usage, filter life may
need to be replaced sooner.
See your water dealer for
more information.
Step 1:
Remove the top lid of the
cooler. Unscrew the 3
Phillips screws that hold
down the internal lid and lift it out of place. This will expose the filter area.
Step 2:
Pull the filter out enough to unscrew the cartridge from the head. When the cartridge is free,
move the head aside, pull the cartridge out and lower a new one in its place, screwing it firmly
into the head. Lower the filter back into its place.
Step 3: The new filter cartridge must be purged before it is used. Shut off the inlet water supply and
see Step 8 under the Installation section for instructions on how to safely do this.
Step 4:
Turn on the inlet water supply. Dispense water; check for leaks. Replace the covers
removed in Step 1.
Step 5:
Note the date of filter change on the filter replacement sticker on the back of the unit.