Haws 2500.CT User Manual

Page 6

6/13

Model 2500.CT

Page 6 of 12

Step 9:

Turn on the inlet
water supply to fill
the system. Check
the inlet tubing and
the system for
leaks. Reinstall the
inner lid and
replace the top lid.

Step 10:

Make sure that the
hot water tank
power switch on
the back of the
cooler is in the
“Off” position. Plug the cooler into 115VAC wall power using the supplied power cord.

Step 11:

Press and hold the “Cold” button (see diagram under Operation section) until the ring around
the “Water” button turns blue. Press and hold the “Water” button until water begins to come
out of the nozzle (if it does not emit from the nozzle after a moment, consult the
Troubleshooting section).

Step 12:

Press and hold the “Hot” button (see diagram under Operation section) until the ring around
the “Water” button turns red. Press and hold the “Water” button. The hot tank will fill and
water will eventually begin to dispense. Stop and restart dispensing until all air is evidently
gone from the system

. Flip the hot tank power switch to “On.”

NOTE: Turning on the hot tank power switch without first filling the tank can damage
the unit.

SIP Sanitization Setup

The cooler may be sanitized using the integral SIP (Sanitize in Place) ozone technology.
This can be done by using the default daily sanitization mode (see below) or by running the
SIP manually for a more complete cleaning (see Maintenance section).
NOTE: The system is not available for use while the SIP sanitization is running
(approximately 1 hour), so it is generally preferable to set it to run when the cooler is
least likely to be needed.

Step 13:

Press and hold the white button on the back of the cooler (see diagram above) until it has
beeped twice (about 7 seconds). The light

ring around the “Water” button will begin flashing

white.

Step 14:

The SIP system is designed to activate automatically every 24 hours. Press the white button
X number of times, where X equals the number of hours from the current time until the
desired daily sanitization time, then press

the “Water” button to save the new setting.

Example: you are setting up the SIP sanitization and it is 2PM. You want the SIP to activate
every day at 10PM, so you press the white button 8 times, and

then press the “Water” button.

NOTE:

Pressing a button other than the “Water” button or the white SIP button, or waiting 15

seconds without pressing any button, will exit from setup mode without saving.

NOTE: Entering setup mode (as done in Step 13

) and immediately pressing the “Water”

button will turn the SIP functionality off.

Step 15:

Sanitize the exterior of the unit with Clorox

Anywhere

Hard Surface

Daily Sanitizing

Spray before using.

See the Maintenance section for further instructions on the SIP user interface.