State Tilt Roof - Manual (Page 6)

6
Figure 16.
MOUNTING
BRACKET
ROOF
RAFTER
SPACER
BLOCK
WOOD SPANNER
(2” x 4” or 2” x 6” LUMBER)
PLYWOOD
SHEETING
STAINLESS STEEL
ALL THREAD ROD, NUT,
LOCK WASHER &
FLAT WASHER
CP COMPRESSION
WASHER
DECKING/WOOD
SCREWS
FENDER WASHER
LOCK WASHER & NUT
LEAD
FLASHING
FLASHING
ROOF
TILES
ROOF
RAFTER
SS NUTS
EPDM
WASHERS
REDUCING
COUPLING
SUPPORT NUT
ROOF
MEMBRANE
23. Install the mounting brackets on top of the support nut
with the stainless steel flat washer, lock washer, & nut.
See Figure 16.
24. Install the mounting brackets on top of the support nut
with the stainless steel flat washer, lock washer, & nut.
See Figure 16.
25. Repeat steps 1 - 24 as needed for the remainder of the
mounting bracket locations.