Racing Electronics SC150 - Manual (Page 17)

Scanning
Note: When you turn the scanner on it will be in the
same Mode it was in when you turned it off.
Bank Scanning
1. Look at the upper left corner of the display. If BANK
is not displayed, press B
.
2. If SCN is not displayed in the lower left corner of the
display, press
S
. The SportCat should begin
scanning.
3. If HOLD appears at the bottom of the display, press H
or
S
to begin scanning.
The indicators for the selected Banks (1 through 10) appear
on the display. The indicator of the Bank currently being
monitored flashes. While the SportCat is scanning, the
word SCAN moves across the display.
Scanning stops on any active channel that is not “Locked
Out”, and displays the Channel Number and frequency.
Scanning resumes automatically after the transmission stops.
4. You can deselect any bank(s) from being scanned
by entering the number of the bank. The deselected
bank indicator(s) disappear from the display, and
those channels will not be scanned. This procedure
helps to speed up the scanning cycle.
Note: One Bank must always be active. You cannot
deactivate all 10 banks at the same time. If you try to
deactivate all 10 Banks, Bank 1 will automatically be
active.
5. To restore any bank for scanning, just enter its
number again. The bank indicator will reappear on
the display.
6. To stop scanning any time, press
H
. (HOLD
appears on the display.) The scanner remains on
the displayed channel, and only the bank indicator
for that channel appears. Press
H
again or
S
,
to resume scanning.
7. When you are stopped at a channel, you can press
d
to step down a channel, or
u
to step up a channel.
Press and hold either key to rapidly step through the
channels.
Note: You do not skip a locked out (“L/O”) channel when
you use
d
or
u
or GO TO.
17
C:...sc150om.vp
Wed Dec 17 10:26:43 1997
Color profile: Disabled
Composite Default screen