Racing Electronics RE1000 - Manual

KEY-LOCK
With the Scan in Off Mode: To lock the keypad (all 16 keys)
Press & Hold “F” & Arrow Down To Disable the Key-Lock. Press & Hold “F” & Down Arrow
Again and your buttons become active again.
AUTO-LIGHT
With the Scan in Off Mode: For lighting up the display any time the keyboard is pressed or
the scanner is receiving. (Note: This feature will deplete the battery faster. Not
recommended or necessary for daytime).
Press & Hold “F” & UP Arrow to turn on the Auto-Light feature and Press & Hold “F” & UP
Arrow again will turn Auto-Light Off.
LOCK OUT Mode (Explanation)
With the Scan in Off Mode: Used to eliminate a channel from being accessed using the
Up/Down Arrow or the Scan List, this convenient feature speeds up your scanner. If a driver
is not in the race you are attending, LOCK OUT is a great way to store the information for the
future. (LOCK OUT Mode is set in Programming Mode)
000
1
GUIDE
USER
RE1000 Scanner Controls/Features
10. Scan or Right Arrow
11. 1 or Clone
12. 2-9 or A-Z
13. Symbols or MRN/PRN
14. 0 or _ (space)
15. Enter
16. Belt Clip
17. Battery Door and Latch
18. Batteries (3 AAA Alkaline Recommended) 1. On/Off Volume
2. Antenna (fixed)
3. “F” Function
4. “SQ” Squelch
5. Programming/Cloning Port
6. Headset Jack (3.5mm Mono)
7. Display
8. Gear Key or Left Arrow
9. Arrow Up/Down or Light/Key Lock
4
5
15
16
17
18
2
13
12
3
6
7
1
14
8
9
10
11
BASIC OPERATION
Power Off/On-Volume
The knob on the top of the scanner turns the scanner on/off and adjusts the volume. Push
& hold the “SQ” button on the side of the scanner to turn on the background noise. Tune
the volume to a comfortable level by rotating the Volume Knob.
Scan Off/On
The “Scan” Button turns the Scan feature On & Off. Push “Scan” to Start Scan , Push “Scan”
again to stop Scan. The “Sc” symbol in the display will flash when Scanning and will be solid
when not scanning.
*NOTE: Some of the following operations require the scanner to be set in Scan Off mode.
Quick Tune
With the Scan in Off Mode: To Quick Tune to a particular driver (Example Tony Stewart in
the 14 Car), Press the 1, 4 & Enter Keys. This will change to Car 14.
REmember
The scanner will return to the previous channel when Scan is stopped. If you were listening
to Tony Stewart on car channel 14 and push scan, the scanner REmembers that channel
when you stop scan and will return to that same channel when Scan is pushed again to stop
scan.
Channel Up/Down
With the Scan in Off Mode: The Up & Down Arrows will manually change the channel, one
channel at a time, either up or down. (If the car/driver is not showing up using the Up/Down
Arrow, see “Channel Lockout” in the Advanced Operation Instructions).
REset
Your scanner was pre-programmed with the most accurate frequencies, settings and features.
If you pushed the wrong buttons and made changes to the scanner, you can REset the
scanner to what was initially programmed for the weekend. With the scanner off, simply
push and hold “F” & “SQ” and turn the scanner on and the scanner will REset to the original
programming for the weekend. (Note: Any changes made will be lost and REset to the
earlier Programmed/Cloned settings).