Removing front cover, Installation – Outback Power Systems GS8048 Installation Manual User Manual

Page 23

Text mode
Original mode

Installation

Removing Front Cover

The front cover must be removed in order to access the Radian inverter’s AC terminals and other

connections. These include the “Remote” and “Batt Temp” ports, as well as several sets of auxiliary

terminals.
Twenty-two machine screws are located around the perimeter. Remove these screws with a Phillips
screwdriver. Once they are removed, the cover can be lifted off.

Figure 10 Cover Screws

NOTE: The Radian inverter may ship with only a few screws installed to make it easier to perform the
initial installation. The remaining screws are included in the hardware kit.

Screws