Dee Zee FX12358 - Manual (Page 4)

PN 325 X2
WRENCH/RATCHET
3/8", 7/16", 9/16"
TAPE
13mm, 18mm MEASURE
TIN SNIPS
PHILLIPS SCREWDRIVER 1/8" 3/16" 1/4"
OR PHILLIPS BIT FOR DRILL DRILL BIT
Place the bulb-seal gasket [B] onto the backlip of the runing board [A]. Cut the bulb-seal gasket
with tin snips so that it is flush with the ends of the board
Slide two 1/4 x 3/4" slotted hex head bolts [H] into both of the bolt channels on the bottom
side of the running board.
TOOLS REQUIRED
1
Y
8mm WASHER
FX 12958 2 OF 17 6/1/2011