Dee Zee FX12358 - Manual (Page 18)

Align the bolt in the channels on the bottom of the running with the slots in the angle braces and
insert the bolts into the slots. Attach the running board to the braces using the 1/4" flat washers [I],
and the 1/4" hex nuts [J]. Note: the board may need to be angled back to get the bolts aligned
with the slots in the bracekts. Also the flap should be located against the wheel well.
Once the board is aligned with the cab board and the step surface of the side box board matches
the cab board. Tighten the bolts the attach the running board to the angle braces and the bolts
that attach the angle brace to the main upright brace using a 7/16" wrench and socket
6
FX 12958 16 OF 17 6/1/2011