Dee Zee DZ16336 - Manual (Page 8)

Thread 2 of the 8mm x 25mm bolts through the slots in the braces into the nutserts.
Only engage the bolts a few threads into the nutserts. Then pushing up on the brace to put tension on the
threaded plate tighten the top until it is snug but not completely tight.
Snug the bottom bolts also.
Using two of the carriage bolts [I], two 1/4" washers [J] and two 1/4" nuts [K], loosely attach the support
bracket [M] to the pinch weld on the truck. The bent flange with two holes in it should be point up.
The support brackets are left hand/right hand. Select the appropriate one for each mounting location.
Do not tighten at this time.
7
6
DZ 16336 6 of 9 7/10/2013