Dee Zee DZ16336 - Manual (Page 14)

Use the nutsert set tool [D] to crimp the nutserts in the holes.
Hold the nut on the set tool with a 15mm wrench. Tighten the bolt in the set tool with a 13mm
socket.
Torque the nutserts to the spcification below to insure they are set correctly.
Put a 8mm x 25mm bolt [F] through the top hole in the braces and thread into the
8mm threaded plate [G] until the bolt starts to come through the threaded plate.
3
2
3 of 9 7/10/2013