beautypg.com

Rack & pinion cradle system – Flaming River Chevelle/El Camino Rack and Pinion 1968-72 User Manual

Page 14

background image

Rack & Pinion Cradle System

68-72 GM A Body

Power Steering

01/15/07

12

Universal Joint System.

1) Install support-bearing mount onto the rear control arm bolt. (Picture below). Note: The angle of this

mount is set for most applications. Some adjustment may be necessary for the correct angle and u-
joint alignment.

2) We recommend the use of ¾” wood dowel rod to mock up the steering shaft to obtain the correct

length of the shafts.

3) Install your shaft kit and snug each set screw so that it will leave a mark in the shafts.

4) Remove shaft and dimple each setscrew mark using a ¼” drill bit. (As shown below.)

Continued on Next Page