Flaming River Camaro Rack & Pinion Cradle Kits 1970-81 - Manual (Page 2)

70-81 Camaro Rack & Pinion Cradle System
70-81 Camaro
Rack & Pinion Steering
100808 revised
1
Index
For safety disconnect battery cables and ensure that vehicle is properly supported by jack stands.
NOTE: Hoses (FR1610) Pump Mounting Brackets (FR1611) is sold separately and is not included in this
kit. Factory inner and outer tie rod ends must be used with this rack and pinion kit.
Before paint or powder coating of the rack and pinion cradle system we recommend that you pre-fit the
system to ensure proper fit.
Installation hardware and inventory PG 2
Electrical System Verification PG 3
(Only if using a Flaming River Column)
Removal of Factory Steering Shaft PG 3
Removal of Factory Steering Column PG 4
(Only if using a Flaming River Column)
Steering Box & Linkage Removal PG 4-5
Installation of Flaming River Column (For kits including new Column)
Installation of New Flaming River Tilt Column PG 6
Electrical System Notes PG 7
Steering Wheel Installation PG 7-8
Installation of the Flaming River Rack & Cradle
Installation of Rack and Cradle PG 8-10
Section 4 Universal Joint Installation
A. Universal Joint and Steering Shaft Installation PG 10-11
Torque Specs PG 11
Warranty Disclaimer
Because of their intended usage, the manufacturer makes no warranties whatsoever express or implied, oral or written, to purchasers of their
products regarding performance, safety, fit merchantability, or length of service. Purchasers are responsible for selection of proper goods and
must rely on there own skill or judgment that such goods are suitable for purchasers application.