DAVIS WindScribe User Manual

Page 2

Secure to handlebar or strut using Velcro

strap. Fits

bars

" to 1

" in diameter (19 to 38 mm).

3. Attach Wrist Lanyard. Feed one end of lanyard

through mounting hole to form a small loop. Feed

opposite end through loop and pull tight. Slide bead to

adjust fit.

Power Off / Clear Readings / Escape. When you

press and hold ON, the display cycles through three

modes: OFF, CLr (clear), and ESC.

• To power off, release when OFF is displayed. Also

turns off after 5 minutes of no button activity and

zero wind speed.

• To clear max, min, and avg readings, release when

CLr is displayed.

• To return to operation without clearing readings,

release when ESC is displayed.

Hold Current Reading. Press HOLD to capture cur-

rent reading in upper display. LCD indicates hold in

progress. Press again to release.

Turn Light ON. Press TEMP and WIND at the same

time. Light turns off after 10 seconds.

Tripod Mounting. Attach tripod to tripod thread (

" x

20).

Telltale. Tie a piece of yarn or string (not included) to

telltale slot on front of unit to help determine wind

direction.

Operation

Power On. Block both ends of wind barrel to ensure

correct zero speed setting, then press ON. CAL indi-

cates unit is calibrating.

Functions

Change Temperature Display Mode. Press TEMP to

cycle through: temp, max temp, min temp, wind chill,

and min wind chill.

Change Temperature Units of Measure. Press and

hold TEMP until you see desired unit.

Change Wind Display Mode. Press WIND to cycle

through wind speed modes; speed, 5 sec avg speed,

running avg speed, max speed, and min speed.

Change Wind Speed Units of Measure. Press and

hold WIND until you see desired unit: mph, knots, f/s,

fpm (x10), m/s, or km/h.

Measure Wind Speed. Point front of wind barrel into

wind to measure positive (+) wind sped or headwind.

Point rear of wind barrel into wind to measure negative

(–) wind speed or tailwind.