DAVIS Windex AV Installation Instructions - Manual (Page 3)

Slide Windex AV vane components onto whip.
Install in the order shown:
If you removed the whip, reinsert it into the antenna body.
Tighten lock nut or set screw.
Slide vinyl keeper down so vane is held in place yet turns freely.
3
4
5 Final assembly.
Metz brand antenna:
Refer to drawing at right.
• Disconnect antenna cable.
• Remove lock nut.
• Unthread coupler from bottom of antenna body.
• Replace the Metz bushing with one of two plastic bushings
supplied (try thicker bushing first).
• Thread coupler back onto the antenna body.
• Place Metz O-ring in position.
• Place stainless steel washer over O-ring.
• Slide the reference tab support wire over the coupler.
• Insert coupler into Metz bracket.
• Thread lock nut onto coupler. If not enough threads are available to
secure lock nut, remove coupler and replace bushing with thinner
bushing supplied. Repeat assembly.
• Position reference tab arms so they face aft, aligned with centerline
of boat.
• Tighten lock nut.
• Reconnect antenna cable.