DAVIS LUBE II - Manual (Page 2)

3. Use one of three oiling techniques, turning the
steering wheel back and forth as lubricant is applied:
(1) Max-Lube™ (#422). This is the preferred lubricant
(shown at right). Cut the very tip off the Max-Lube
bottle and insert nozzle into Lube II oiling hole.
Squeeze in lubricant until full. Thread in the black
thumbscrew cap supplied.
(2) Synthetic 90w gear oil. Insert oil, thread in thumb-
screw cap.
(3) Lithium complex grease. Thread supplied zerk fit-
ting into Lube II oil hole. Apply one-half pump
only of grease with grease gun. Excessive grease
may force seal out of seat or cause grease lock
and possible steering failure. If seal comes free,
clean nut and seal, press back into place; do not
add more grease.
4. After lubricating, reconnect steering linkage.
Replacement Parts
Contact your dealer or Davis Instruments for replacement parts.
R425A Rubber Seal
422 Max-Lube™ Extreme Service Lubricant, 3 fl. oz. (90 mL)
425_Engl.pdf June 2008
3465 Diablo Avenue, Hayward, CA 94545, U.S.A.
Phone (510) 732-9229 • Fax (510) 732-9188
[email protected] • www.davisnet.com
Uilenkade 12 • NL-3336 LP Zwijndrecht • The Netherlands
Phone +31 78 6194316 • Fax +31 78 6192689
[email protected] www.davisnet.com