Sper Scientific 850055 pH Meter - Advanced - Manual (Page 9)

9
SETUP MODE
The advanced Setup Mode allows you to customize the
following meter preferences and defaults:
 P1.0 Memory Transmission
 P2.0 Clear Memory
 P3.0 Electrode (pH probe)
 P4.0 Buffer Solution (pH)
 P5.0 Ready Function
 P6.0 Temperature Units
 P7.0 Real Time Clock
 P8.0 Reset
To enter Setup Mode, press SET for more than 2 seconds
while the meter is in Normal Mode.
Note...
To exit Setup Mode without saving, press ESC until the
Normal Mode appears. If the meter is in Setup Mode, press
ESC twice to exit.
P1.0 Memory Transmission
To transfer stored data from the meter to the computer:
1. Connect the USB cable to the right side of the meter,
then connect the other end of the cable with the D-sub
connector to the computer’s serial port. Run the
software associated with this feature.
2. Press SET for 2 seconds to enter setup. The “TR” icon
appears on the middle of the LCD display and P1.0