beautypg.com

1 preparing for calibration, 2 carrying out calibration runs – SIGMA RC 1209 User Manual

Page 24

background image

228

www.sigmasport.com

6.4.1 PREPARING FOR CALIbRATION

1 Put on the chest belt or attach the HipClip.
2 Go to a measured distance of at least 800 meters long.
Tip: The inside lane of a track is 400 meters.
3 Select “calibration” in the setting mode.
4 Press the SET button. The running computer detects whether you

carry the HipClip or the chest belt. The function “Running”

is displayed.

Tip: If you want to calibrate the RC 1209 for “Walking”, select

the function “Walking” with the SPEED (+) button.

5 Press the SET button. The running computer shows on the display

what you have to do.

6 CALIbRATION & CORRECTION FACTOR

6.4.2 CARRYING OUT CALIbRATION RUNS

1 Always start 20 meters from the starting line of the measured

distance (flying start).

2 Once you cross the starting line, press the START/STOP button.

The measurement begins.

3 After you have run the measured distance, press the START/STOP
button.
4 Now adjust the displayed value by pressing the PULSE (-)

or SPEED (+) button to the actual distance run.

5 Press the SET button. The slow calibration run is saved.
6 In the display now you can see the prompt “Run (walk) fast/

press Start” alternately. Follow steps 1 - 5 again to calibrate the

fast run.

Note: After you have performed the first calibration, the calibration
menu will change. If you redo it, you have the opportunity at the
beginning to distinguish between the following options: ON, OFF and
NEW. Select ON, then run in training mode with calibrated values.
Select OFF, then run with an uncalibrated RC 1209. Select NEW, then
re-calibrate the RC 1209.