Aiwa NSX-D70 - Manual (Page 16)

16
En
Programmed Edit Recording
As you program the CD tracks to record, Programmed Edit
Recording displays the remaining recording time for each side
of the tape, so you can easily select a set of desired tracks
within the length of your tape.
1 Insert the recording tape in DECK 2.
2 Turn the Dial Function to select the CD function
and load disc(s).
3 Press SHIFT+CD EDIT/CHECK twice on the
remote control.
"PRGM" and "EDIT" are displayed and "P C-00"
appears on the display.
4 Press the numbered buttons on the remote
control to enter the length of the recording tape.
10 to 99 minutes can be specified.
• f, g or MULTI JOG can also be used to specify
tape length.
5 Press DISC DIRECT PLAY 1-3 to select a disc.
Then, press the numbered buttons on the remote
control to select the first track to be recorded on
side A.
- To select the 25th track, press +10, +10 and 5.
- To select the 10th track, press +10 and 0.
6 Repeat step 5 to select the rest of the tracks for
side A.
The remaining recording time of side A is displayed. You
cannot select a track with a longer playing time.
7 Press SHIFT+CD EDIT/CHECK on the remote
control to switch to side B and select the tracks
for the side.
8 Press SHIFT+CD EDIT/CHECK on the remote
control to switch back to side A.
Side A
Tab for side A
9 Press wREC/REC MUTE to start recording on
side A.
On the remote control, press REC MODE and then press
wREC/REC MUTE within 3 seconds.
The tape is rewound to the beginning of side A and
recording starts.
Go to the next step when recording on side A finishes.
10 Press SHIFT+CD EDIT/CHECK on the remote
control to switch to side B.
11 Turn over the tape and press wREC/REC MUTE
to start recording on side B.
On the remote control, press REC MODE and then press
wREC/REC MUTE within 3 seconds.
•You cannot program more than 30 tracks. "FULL" is
displayed.
•You cannot program a track with a track number larger than
30.
•Recording cannot start from a point halfway in the tape.
To stop recording
Press s. Recording and CD playback stop simultaneously.
To check the program
1 Before recording, press SHIFT+CD EDIT/CHECK on the
remote control to select side A or B.
2 Press f or g repeatedly. The track number and
program number are displayed in succession.
To change the program of each side
Press SHIFT+CD EDIT/CHECK on the remote control to select
side A or B, and press s to clear the program for the selected
side. Then, select tracks again.
To clear the edit program
Press s twice so that "EDIT" disappears from the display.
To prevent accidental erasure
Break off the plastic tab of the cassette tape with a screwdriver
or other pointed tool. To record on the tape again, cover the
detection slot with adhesive tape.