Quick Fuel Technology 34-105 Billet Metering Block - Manual

270-793-0900
www.quickfueltechnology.com
P/N 34-105
Installation Instructions for 34-105 Billet Metering Block
Thank you for purchasing our Billet Two Circuit Gasoline Metering Block Conversion Kit.
Installation is essentially the same procedure as replacing a conventional metering block. There are a couple
of features and tuning aspects of this metering block you should become familiar with. At the top of the
straight “V” is the idle feed restriction (see illustration below). This screw-in restriction controls the fuel side
of the idle and off-idle air/fuel mixture. Your primary metering block comes with .033” idle feed restrictions. The number
“33” will be stamped on the head of these restrictions.
The emulsion holes, the three emulsion bleeds in the serpentine slot are pre-calibrated and intentionally do not
have any bleeds installed. These pre-calibrated emulsion holes offer improved performance over your original
metering block and are adequate for the majority of most applications.
An additional feature of the metering block is an adjustable power valve channel restriction. These are
the holes immediately behind the power valve 1” hex head. The purpose of these restrictions is to add
supplemental fuel to the main well during wide open throttle operation or when the engine load drops the
manifold vacuum below the calibrated value of the power valve. In this metering block the power valve channel
restrictions are .059” and should have the number “59” stamped on the head.
CAUTION: Do not make drastic emulsion or power valve channel size changes as you can significatly alter the
air/fuel mixture ratio and could cause damage to the engine. It is highly recommended that when experimenting
with emulsion calibration you consult one of the many books available on carburetor modification and use one
or more devices that montors air/fuel ratio throughout the operating RPM range.
Emulsion Bleeds
Power Valve Channel
Restriction
Idle Feed
Restriction
We thank you for purchasing Quick Fuel Technology products. We are passionate about about our products and
your performance - if you are experiencing any difficulty in your installation or are having other issues please call
our technical serivce phone line at 270-793-0900. Our business hours are M-F 8:00 am - 5:00 pm Central Time.
©2012 QUICK FUEL TECHNOLOGY 99-34-105 (Rev. 1)
Primary Billet Metering Block Secondary Billet Metering Block