Quick Fuel Technology Blow Out Protection Kit User Manual
Blow out protection kit instructions
Blow Out Protection Kit Instructions
1. Remove throttle body from main body
2. Locate the power valve vacuum passage (note: small hole next to the center
throttle body screws pri. & sec.)
3. Check the drill collar height this should be 9/32” of the drill point exposed)
4. On the main body surface of the throttle body, drill the P.V. vacuum passage until
the drill collar contacts the gasket surface.
5. Remove all chips and deburr if necessary
6. Install the spring provided with the large end of the spring at the bottom.
7. Install the check ball.
8. Position the new seat in the hole and lightly tap it with a drift and small punch until it
is flush with the gasket surface.
9. Reinstall the throttle body.
P/N 99-18
© Quick Fuel Technology 2012
- 34-2 Side Pivot Float Conversion Kit (1 page)
- 67146 Center Pivot Float Conversion Kit (1 page)
- 34-3 Center Pivot Float Conversion Kit (1 page)
- 4500 Booster Conversion Kit (1 page)
- 4500 Alcohol Conversion Kit (4 pages)
- 600-1 Wide Open Throttle Switch (1 page)
- Throttle Shaft Kit (1 page)
- 34-9 Secondary Metering Block with idle mixture screws (1 page)
- 30-816 Check Valve Kit (1 page)
- 30-817 Lower Housing & Seal Kit (1 page)
- 30-811 Installation Instructions Rotor and Vane Kit (1 page)
- 4700 Series Throttle Linkage Set Ups (1 page)
- 10-5 High Flow Throttle Shaft (1 page)
- 350 CFM Metering Block Upgrade (1 page)
- Methanol Main Body to E85 Calibration (3 pages)
- Carburetor Main Body (3 pages)
- 500 CFM Circle Track Two Barrel Carburetor (1 page)
- Electric Choke (1 page)
- REMANUFACTURED CARBURETOR (1 page)
- Quick Set Adjustable Vacuum Secondary Housing (1 page)
- 34-66 / 34-111 Billet Secondary Metering Block Conversion Kit (1 page)
- 34-133 Billet Secondary Metering Block Conversion Kit (1 page)
- 30-125-1 / 30-125-1R Electric Fuel Pump (1 page)
- 30-140 Electric Fuel Pump (1 page)
- 30-155 Electric Fuel Pump (1 page)
- 30-175F Billet Electric Fuel Pump (1 page)
- 30-899 By-Pass Regulator (1 page)
- 30-805 Fuel Pressure Regulator (1 page)
- 36-E85 eChecker E85 Test Tube (1 page)
- 3 Circuit Billet Metering Block (1 page)
- 34-105 Billet Metering Block (1 page)
- 34-104 Fuel Bowl Extension Kit (1 page)
- 34-10 Billet Metering Block (1 page)
- 34-8 Billet Metering Block Kit (1 page)
- 34-6 Billet Metering Block (1 page)
- 34-106 Billet Metering Block Conversion Kit for E-85 Fuel (1 page)
- 600-2 Wide Open Throttle Switch (1 page)
- 4500 (Newer Style) E-85 Conversion Kit (3 pages)
- 49-4SS BILLET THROTTLE CABLE BRACKET (1 page)
- 10-6 High flow secondary throttle shaft kit (1 page)
- 34-100 4 BBL Fuel Bowl Conversion Kit (1 page)
- 30-1803 Billet Pressure Regulator (1 page)
- 30-1900 By-Pass Regulator (1 page)
- 30-1899 By-Pass Regulator (1 page)