Avaya IP Office 15-601082 - Manual (Page 24)

Wireless Installation and Configuration Guide
Wireless Installation and Configuration Guide Page 18
IP Office [15-601082] Issue [1] (1 June 2006)
AVPP Configuration
The SVP-II Configuration screen allows you to set the mode of the AVPP for an IP environment. It is
also where you can lock the AVPP for maintenance and reset the AVPP after maintenance.
If the IP address is changed, the AVPP will automatically lock for maintenance. When this Maintenance
Lock occurs, the AVPP must be reset upon exit. All active calls are terminated during a reset.
From the main menu, scroll to SVP-II Configuration and press Enter.
For the AVP 10 or 20, the following screen is displayed:
For the AVP 100, the following screen is displayed:
Complete the configuration changes:

Phones per Access Point - enter the number of simultaneous calls supported for your type.
Access point specifications are detailed in the configuration notes for each brand and type.

802.11 Rate - select 1MB/2MB to limit the transmission rate between the wireless phones and
access points. To allow the wireless phone to determine its rate (up to 11Mb/s), select
Automatic.