Mc Leod Pro Series Clutch - Manual (Page 3)

11) Rotate the barrels to meet the pressure plate cover and torque to 100 ft. lbs.
12) To move the pressure plate, loosen nut and rotate adjusting barrel up or down to achieve
proper height (See Figure 1). Note: the stand barrels have numbers; each number represents .010”
from the next. Once the clutch is finally adjusted these numbers may vary slightly from barrel to
barrel.
13) Now that the pressure plate is close to its final setting, use the dial indicator again to obtain
the exact pressure plate height. Slip the dial indicator into one of the six checking holes, the
needle should go around one time, and back to zero.
14) Be sure all adjusting screws and lock nuts are set. Loosen each locknut and back off one
turn. Screw the adjuster screw into the pocket until it contacts the adjuster. Hold the screw and
tighten the lock nut.