Mc Leod RST/RXT - Manual

RST & RXT Street Twin Clutch Installation Instructions
Congratulations! You have just purchased the finest Street Twin clutch system on the market today. The
RST and RXT Street Twin clutch systems are capable of handling extremely high horsepower engines in
street driven vehicles. The key benefits with this system are low rotating mass, lighter than stock pedal
effort and dual discs for extreme holding capacity with exceptional release qualities. Properly installed,
this clutch system will provide the strength and durability you have come to rely on in all of the McLeod
Racing family of products.
1) See Figure 1 for component parts identification and alignment mark!
Figure 1 Figure 2
2) Remove six pressure plate nuts, lock washers and flat washers and set aside.
3) Lift off pressure plate and top disc from the adapter ring and set aside. Figure 2.
4) Inspect flywheel for chipped teeth on Ring Gear and be certain the flywheel/disc engagement
surface is clean, flat and free of oil and/or grease. Be certain the pilot bearing is in place and is
clean and free of nicks and burrs. If damaged, replace the pilot bearing. Test fit the pilot tool to see
how far the tool engages the pilot bearing. See Figure 3.
I0004