Mc Leod Line Launch - Manual

Line Launch System Installation Instructions
The McLeod Racing Line Launch System will allow you to hold the released clutch at the starting line and
release the clutch when you let pressure off the momentary switch. This system is engineered to operate with
hydraulic clutch linkage only. The purpose of this system is to improve reaction time when drag racing. It is
quicker to release a switch than it is to let your foot off the clutch pedal. The momentary switch included with
this kit is designed to control both the hydraulic throw out bearing/slave cylinder and a Line Lock for the brake
system.
1) Determine a location on the vehicle to mount the Line Launch System. Usually near the master
cylinder for the slave cylinder. The McLeod Line Launch System must be mounted vertically! It cannot
be mounted in a horizontal position! Be sure to leave space for hydraulic lines and electrical
connections. Hard lines or high pressure braided stainless lines are recommended. The Line Launch
system includes AN-4 male fittings.