Asus P4GE-V - Manual (Page 46)

2-20 Chapter 2: Hardware information
4. Chassis intrusion connector (4-1 pin CHASSIS1)
This lead is for a chassis designed with intrusion detection feature.
This requires an external detection mechanism such as a chassis
intrusion sensor or microswitch. When you remove any chassis
component, the sensor triggers and sends a high-level signal to this
lead to record a chassis intrusion event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted
with a jumper cap. If you wish to use the chassis intrusion detection
feature, remove the jumper cap from the pins.
5. SMBus connector (6-1 pin SMB1)
This connector allows you to connect SMBus (System Management
Bus) devices. Devices communicate with an SMBus host and/or other
SMBus devices using the SMBus interface.
P4GE-V
®
P4GE-V Chassis Alarm Lead
CHASSIS1
+5VSB_MB Chassis Signal GND
(Default)
P4GE-V
®
P4GE-V SMBus Connector
SMB1
1
SMBCLK
Ground
SMBDA
T
A
+3V
FLOA
TING