Manley The WAVE DAC/Preamp 20 Bit Version Serial Code WAVE000-015 1999 - 2002 - Manual (Page 17)

MAINS CONNECTIONS
Your unit has been factory set to the correct mains voltage for your country. The voltage
setting is marked on the serial badge, located on the rear panel. Check that this complies
with your local supply.
Export units for certain markets have a moulded mains plug fitted to comply with local
requirements. If your unit does not have a plug fitted the coloured wires should be con-
nected to the appropriate plug terminals in accordance with the following code.
GREEN/YELLOW EARTH terminal
BLUE NEUTRAL terminal
BROWN LIVE terminal
As the colours of the wires in the mains lead may not correspond with the coloured marking
identifying the terminals in your plug proceed as follows;
The wire which is coloured GREEN/YELLOW must be connected to the terminal in the
plug which is marked by the letter E or by the safety earth symbol or coloured GREEN or
GREEN and YELLOW.
The wire which is coloured BLUE must be connected to the terminal in the plug which is
marked by the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal in the plug which is
marked by the letter L or coloured RED.
DO NOT CONNECT/SWITCH ON THE MAINS SUPPLY UNTIL ALL OTHER
CONNECTIONS HAVE BEEN MADE.
THERE IS A SWITCH INSIDE THE POWER SUPPLY FOR CHANGING THE
MAINS VOLTAGE. IT IS LOCATED DIRECTLY BEHIND THE AC MAINS
BLOCK WHICH CONTAINS THE FUSE & POWER SWITCH ETC. IT IS
CLEARLY LABELLED FOR 110 AND 220 VOLT AC MAINS. ALWAYS
DISCONNECT THE IEC MAINS CABLE BEFORE OPENING THE SUPPLY AND
ALWAYS ALLOW 30 MINUTES TO ALLOW THE CAPACITORS TO
DISCHARGE FOR SAFETY SAKE.
17