JELD-WEN JII027 Wood Patio Doors without Exterior Trim or Nailing Fin User Manual

Page 8

INSTALLATION INSTRUCTIONS

for Wood Patio Doors without Exterior Trim or Nailing Fin (JII027)

COMPLETE INSTALLATION - CONTINUED

Please visit jeld-wen.com for finishing instructions, warranty and care

and maintenance information.

Thank you for choosing

COMPLETE INSTALLATION

• On the exterior of

step down landings,
install support trim
underneath the sill
where it extends past
the landing. Position
trim snugly against the
bottom of the sill toe.

• Adjust patio door for

best operation.

• Create a continuous

air seal on the interior
between the rough
opening and the frame
with low expansion
foam or backer rod
and sealant.

Gap

Backer

rod

Gap

Sealant

joint

AFTER INSTALLATION

• Install exterior wall surface within seven days of installation.
• Maintain gap of 1/4"-3/8" between door frame and final exterior wall

surface (siding, stucco, etc.).

• Seal this gap on the sides with backer rod and sealant. For step-down

landings, also seal under the patio door sill with a discontinuous joint.
Do not apply sealant on top of the drip cap.

• Seal any gaps or openings at end of horizontal mull joints with

sealant.

• Remove protective film (if applicable) on glass within one year and

immediately from cladding.

• Protect recently installed units from damage from plaster, paint, etc.

by covering the unit with plastic.

• Finish all exposed wood surfaces immediately following installation.

All trademarks, service marks, logos and the like (whether registered or unregistered) are owned or controlled by JELD-WEN, inc. or others. Unauthorized use or duplication

of JELD-WEN intellectual property is prohibited.
JELD-WEN reserves the right to change product specifications without notice. Please check our website, jeld-wen.com, for current information.

(05/14)