Nilfisk-ALTO SR 1450 B-D - Manual (Page 58)

USER MANUAL
12 33014811(1)2005-07 A
PROBLEMS AND REMEDIES
The following table shows the most frequent problems that may arise during the use, the possible causes and the suggested
remedies to solve them.
PROBLEMS AND REMEDIES
WARNING!
When applying a recommended solution, always follow the instructions relating to it.
NOTE
Do not hesitate to contact Nilfisk-Advance if a problem cannot be solved by following the instructions
provided.
PROBLEM CAUSE REMEDY
Heavy material not collected/traces of dirt
left behind during use Excessive drive speed Decrease drive speed
Light print Adjust trace
Worn out broom Replace brooms
Broom bristles bent or tangled with steel wire,
ropes etc. Remove any tangled material
Excessive amount of dust left on the ground
or coming out of skirts Fan off
Clogged filters Switch on the fan
Clean filters
Material is thrown forward Broken skirt gasket Replace
Engine fails to start See Troubleshooting in the engine Manual
Machine power is reduced Insufficient pump oil feed Check by-pass screw tightening
Check pump pressure (6 to 8 Bar)
Worn motors Overhaul motor
Overhaul pump
The machine fails to run Open by-pass Check by-pass screw tightening
Faulty pedal control Check pressure/replace pedal
No power to pump or motors Overhaul motor
Overhaul pump
Machine fails to brake No brake fluid Top up fluid tank
Brake fluid pump failure Overhaul pump
Air inside the system Bleed system
Jaw cylinders failure Replace cylinders
Worn or greasy brake lining Replace brake lining
Hopper fails to lift/lower Locked distributor Check distributor
Locked cylinder Check cylinder
Waste loss from hopper Worn cylinder gaskets Replace gaskets
Filter shaker fails to operate Broken hopper gasket Replace
Broken push-button Replace
Blown fuse Replace
Excessive motor absorption causes:
–
Worn carbon brushes
– Dirty or worn bearings
– Burnt armature or winding
Replace
Replace
Replace