Alamo 803350C - Manual (Page 103)

OPERATION
VERSA PRO 03/09 Operation Section 4-3
© 2009 Alamo Group Inc.
OPERA
T
ION
88” Cutting Width
Two 10-Gauge Unitized Cutter Housings
1/2” Inboard and 5/16” Wall Cuttershaft
Replaceable Skid Shoes
4-1/2” x 5/16” Wall Cuttershaft
1-5/16” Bore Greasable, Self-aligning Cuttershaft Bearings
53 HP Motor
Belt Drive From Motor to Cuttershaft with Automatic Spring Tension
6” Adjustable Rear Roller
1/2” to 6” Cutting Height
Available in Fine or Coarse-Cut
Front and Rear Safety Deflectors
Automatic Cut-Off Switches
Wing Cylinder Capable of 145 degrees Down & 90 degrees Up
FRONT MOWER SPECIFICATIONS
96” Cutting Width
10-Gauge Unitized Cutter Housing
5/16” Side Plates
4-1/2” x 5/16” Wall Cuttershaft
1-5/16” Bore Greasable, Self-aligning Cuttershaft Bearings
60 HP Gearbox
6” Adjustable Rear Roller
1/2” to 6” Cutting Height
Available in Fine or Coarse Cut
Front and Rear Safety Deflectors
Belt Drive from Gearbox to Cuttershaft with Automatic Spring Tension
The Mower is designed for certain mowing applications and is rated to cut up to a specific
size vegetation (see Mower Standard Equipment and Specifications). DO NOT use this
mower to cut vegetation above the Mower’s rated capacity or to cut any type of non-
vegetative material. Only operate this Mower on a properly sized and equipped Tractor.
Operating this Mower in an application for which it is not designed and/or operating the
Mower with the wrong size Tractor can cause Mower component damage and equipment
failure resulting in possible serious injury or death.
(SGM-14)