Equus 3150 - ABS/SRS + OBD2 Diagnostic Tool - Manual (Page 10)

About the Code Reader
ADJUSTMENTS / SETTINGS AND DTC LIBRARY
8 OBD2
„ The Enter DTC screen displays. The screen shows the code
“P0001”, with the “P” flashing.
2.
Use the UP
and DOWN buttons,
as necessary, to scroll to the desired
DTC type (P=Powertrain, U=Network,
B=Body, C=Chassis), then press the
DTC SCROLL
button.
„ The selected character displays “solid”,
and the next character begins flashing.
3.
Select the remaining characters in the
DTC in the same way, pressing the DTC
SCROLL
button to confirm each
character. When you have selected all
the DTC characters, press the
ENTER/FF
button to view the DTC
definition.
„ If you entered a “Generic” DTC
(DTCs that start with “P0”, “P2” and
some “P3”):
- The selected DTC and DTC
definition (if available), show on
the Code Reader’s LCD display.
If a definition for the DTC you entered is not available,
the “To Link” screen displays.
„ If you entered a “Manufacturer-
Specific” DTC (DTCs that start with
“P1” and some “P3”):
- The “Select Manufacturer” screen
displays.
- Use the UP and DOWN
buttons, as necessary, to highlight
the appropriate manufacturer, then press the ENTER/FF
button to display the correct DTC for your vehicle.
If a definition for the DTC you
entered is not available, an
advisory message shows on the
CanOBD2 Code Reader’s display.
4.
If you wish to view definitions for
additional DTCs, press the ENTER/FF
button to return to the DTC Library
screen, and repeat steps 2 and 3.
5.
When all desired DTCs have been viewed, press the ERASE
button to exit the DTC Library.