EOTech XPS2 - Manual (Page 5)

CAUTION
• Never disassemble the sight’s optical assembly. The optical cavity is purged, nitrogen
filled, and sealed to achieve fog proof performance. Disassembly will void the warranty
and render the sight inoperable.
• When using a Night Vision compatible HWS® in tandem with an NV device, always check
to make sure the sight is off before pressing the NV button to turn on the sight in the Night
Vision mode. Otherwise, it will toggle to the Normal mode and saturate the image intensi-
fier.
• When a sudden increase in resistance is felt in the elevation or windage adjustment
shafts, the end of the adjustment range has been reached. DO NOT TURN THE
ADJUSTMENTS ANY FARTHER OR SERIOUS DAMAGE MAY OCCUR TO THE
SIGHT.
• Never clean the glass surface with a dry cloth or paper towel; always dampen the
glass surfaces prior to cleaning
• All moving parts of the sight are permanently lubricated. Do not try to lubricate
them.
• Do not use deteriorated or corroded batteries. Inspect batteries for rips, tears, dents,
or cuts in the housing. If there is any exposed, internal content of the battery, it could
affect the operation of the sight.
• The XPS2 HWS® units are designed to mount directly to either a 1”(25.4mm) weaver or
MIL-STD-1913 rail specification.