EOTech XPS2 User Manual

Page 33

BORE SIGHTING

Bore sighting is a good preliminary procedure in achieving proper alignment of your sight to the
firearm. A chamber laser/ bore sighter is an aid in achieving collomation.

LIVE FIRE SIGHTING FOR AN M-4 OR M-16

To employ the aiming dot of the HWS® reticle from 10 to 300 meters, the sight can be zeroed at 25
meters using a standard M4/M16 military zeroing target. With the dot aimed at center mass of the
target, the sight should be adjusted so the round lands approximately 1 cm below the point of aim at
25 meters. This method of zeroing ensures hitting a target at 100-200 meters where fine tuning
should be conducted.

Additionally there are custom targets for 25m zeroing used with the M-4 and M16 (see Figure 6), and
for Laser Bore Sighting (see Figure 7). Please visit the manufacturer’s website at www.L-3com.com/
EOTech or contact the manufacturer for copies of these targets

This manual is related to the following products:

300 Blackout EXPS3 Holographic Weapon Sight (Black, Ring/Double Dot Reticle) Model EXPS2 Holographic Weapon Sight (Red Circle-Dot Reticle) Model EXPS2 Holographic Weapon Sight (Green Circle-Dot Reticle) Model XPS2 Holographic Weapon Sight (Ring with Single Red Dot Reticle, Gray) XPS2-Z XPS3 Holographic Hybrid Sight II EXPS2-2 with G33.STS Magnifier EXPS2 Holographic Hybrid Sight I EXPS3-4 with G33.STS Magnifier EXPS3