EOTech XPS2 - Manual (Page 26)

2. No maintenance is needed on the sight’s surface, except to occasionally wipe off with a soft
cloth. Use only a water-based cleaner such as glass cleaner, ammonia, or soap and water.
Never use any solvent-type cleaner such as alcohol or acetone. Do not use gun cleaner to clean or
lubricate the HWS®.
3. All moving parts of the sight are permanently lubricated. Do not try to lubricate them.
4. Never disassemble the sight’s optical assembly! The optical cavity is purged, nitrogen filled,
and sealed to achieve fog proof performance. Disassembly will void the warranty and dam-
age the sight.
2.3 Troubleshooting
The following section outlines measures the operator can take in the event of the named fail-
ure.
Failure: The sight will not power up:
Corrective Action 1: Ensure the battery is inserted properly. The positive (+) end
should be positioned on the side of the battery cap.
Corrective Action 2: Replace the battery with a new, unused battery that contain a full
charge.
18